Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

gateway redundancy in srst mode

Hi,

we are using CUCM 7.0 and 2 no's of 3845 router as voice gateways. both the gateways are configured as mgcp GW.

the requirement is, in srst mode if one GW fails calls should be processed through another VGW. is there any possibility to chieve this ... if so please provide some sample configuration ..

thanks in advance....

2 REPLIES
Bronze

Re: gateway redundancy in srst mode

Bronze

Re: gateway redundancy in srst mode

Since you can only have one SRST reference on the callmanager,

So, what you can do is have an active srst ( hsrp) router and all the phones

will register with the active srst router. If that goes down, then phones

will register to the backup.

However, you may be able to get the calls over both the PRIs by putting in 2

dial-peers, One with the low prefernce number ( hence higher preference ) to

the local PRI, and a second dial-peer with higher preference number ( lower

preference ) to the other gateway. This way, when one of the PRIs gets full,

calls will go out the other PRI. I hope your questions are answered.

375
Views
0
Helpful
2
Replies