Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Gateway Redundancy

I have a client that has two sites that are in an active, passive configuration right now. They want to make it an active/active configuration and use the other one as a back-up. They have a single gateway at each location that does transcoding and local and LD.

I want to load balance between the two sites using device pools, however I want to make it so the gateways are fully redundant as well. If the one in site A fails then calls are routed out of the one in site B and the other way around.

Does anyone have any good articles or solutions here?

1 REPLY
Hall of Fame Super Silver

Re: Gateway Redundancy

Structure your Route Lists so that they reference the other site's Route Group as the secondary RG with the local RG as primary.

HTH,

Chris

107
Views
0
Helpful
1
Replies