I am a customer who has 4 bri channels, where each channel has a line with flat contract with x minuets per mouth. He would like to select each channel in the way he use all the minutes he has per mouth. There is out there a way to dynamic select each channel based on time ? I suppose I should use a thirty-part software, you know someone ?
For now I used a trunk group with longest-idle, but my customer would like to be sure he use all the possible minuets.
thank you really much. Can you please advice me a good book for starting tcl scripting, or give me some web page where I can find more information about this program language. Do I need a special license ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...