Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Getting 7931 to power up with NM-ESW-16

I am running CME v4.x on a 2821 with an NM-ESW-16. I plug a 7931 phone into one of the switch ports. The 7931 does not power up. I have shut and no shut the port and tried all other ports. I can get a 7941 to power up. Does anyone have any idea if the 7931 can be powered from the NM-ESW-16?

4 REPLIES
Hall of Fame Super Gold

Re: Getting 7931 to power up with NM-ESW-16

It should, matter is, that's not the first time similar problems are heard. What exact IOS do you have on the 2821 ? and which exact FW on the 7931 ?

New Member

Re: Getting 7931 to power up with NM-ESW-16

I am not sure what the FW for the phone is. The IOS version is 12.4(15)T3.

Hall of Fame Super Gold

Re: Getting 7931 to power up with NM-ESW-16

Can you try:

power inline delay shutdown 20 initial 300

under interface configuration.

Hope this helps, please rate post if it does!

Hall of Fame Super Red

Re: Getting 7931 to power up with NM-ESW-16

Hi Tun,

I think that you have discovered the porblem here. The 7931 is a Class 3 PoE Device (requires 15.4W);

IEEE 802.3af PoE

Can receive power from IEEE 802.3af-compliant data switches (Class III)

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps379/ps7062/product_data_sheet0900aecd80534259.html

From everything I can find out about the NM-ESW-16 is that it only supplies Cisco Pre-Standard PoE for Class 2 Devices like the 7941 (7W)

Hope this helps!

Rob

293
Views
0
Helpful
4
Replies