Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Getting Dial Tone on incoming calls

When a PSTN caller calls a DID in our office, the voice gateway sends a dial tone. Then the caller can press a valid 4-digit extension, then the call gets routed. I have 'incoming called number .' command in our VOIP dial-peer but the voice gateway still sends a dial tone. The configuration for the VOIP dial peer is as follows:

dial-peer voice 9000 voip

destination-pattern 3...

session target ipv4:10.20.30.40

incoming called-number .

dtmf-relay h245-signal h245-alphanumeric

no vad

Please advise, thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Getting Dial Tone on incoming calls

The incoming called number should be matched on your incoming pots dial-peer not your VoIP dial-peer.

In order for DID to work, you have to configure direct-inward-dial on the pots dial-peer.

The incoming comming called number is then used to match an outgoing dial-peer such as your CallManager VoIP. This is achieved by configuring the incoming-called-number on the same pots dial-peer.

Can you try configuring your dial-peers as follows:-

dial-peer voice xy pots

description Inbound PSTN Dial-Peer

incoming called-number .

direct-inward-dial

dial-peer voice 9000 voip

destination-pattern 3...

session target ipv4:10.20.30.40

no incoming called-number .

dtmf-relay h245-signal h245-alphanumeric

no vad

You may find this document helpful:-

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00801142f8.shtml

Hope this helps.

Allan.

Pls rate helpful posts.

1 REPLY

Re: Getting Dial Tone on incoming calls

The incoming called number should be matched on your incoming pots dial-peer not your VoIP dial-peer.

In order for DID to work, you have to configure direct-inward-dial on the pots dial-peer.

The incoming comming called number is then used to match an outgoing dial-peer such as your CallManager VoIP. This is achieved by configuring the incoming-called-number on the same pots dial-peer.

Can you try configuring your dial-peers as follows:-

dial-peer voice xy pots

description Inbound PSTN Dial-Peer

incoming called-number .

direct-inward-dial

dial-peer voice 9000 voip

destination-pattern 3...

session target ipv4:10.20.30.40

no incoming called-number .

dtmf-relay h245-signal h245-alphanumeric

no vad

You may find this document helpful:-

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00801142f8.shtml

Hope this helps.

Allan.

Pls rate helpful posts.

191
Views
0
Helpful
1
Replies
CreatePlease to create content