Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Our old work phones would take turns around the room. I don't think it was called hunt group, but once logged in to your group/extension...it would go around the room on whose turn it was to answer. Is there a way to do that? Thanks
Dear All,I have both Cisco & Non-Cisco IP Phones which are reigistered in my voice gateway. Now i have got ISDN with DID's. How can i allocate some DN with DID number in order to call in both ways ( each extension 5000 calls outside, its DID should g...
Hello, Apologies for how late this question is! I have read that it is possible to generate a multi san certificate for the call manager service. Each subscriber in the cluster then uses the same certificate for call manager service. If I generate a...
Is it possible to make a 3905 have a second line?
Cisco Unified CM AdministrationSystem version: 12.5.1.13900-152Can anyone explain “last active” and “last registered” on call manager, Find and List Phones page?It’s my understanding that “last active” displays the timestamp when a device was last ac...
I have headset Bluetooth paired with cisco phones and working fine, but auto answer not work. I tried to enable Auto answer with headset on DN but still any incoming call on phone not auto answer, is there anything I miss other than configure auto an...
Hi Team, Please advise on how to upgrade CUCM from version 11.5 (11.5.1.13900-52) to version 15.X. Is there a direct upgrade path available? If not, what are the steps for the upgrade? Thank you.
Newbie CUCM user -- Is it possible to set individual ATA not to dial 9 when dialing out. We do not want to globally change the dial 9 for outside call rule just certain extensions
This is a 2-server cluster of CUCM 12.5It is a small deployment of around 100 phones that don't handle a large volume of calls.I'm pulling logs for the CallManager service.Typically I would expect to be able to go back at least weeks but I can't pull...
Hi All, I'm trying to establish a SIP trunk to an ITSP using TLS and SRTP. We think we have done all the trust point stuff and TLS seems to be OK. However, I'll a little lost on the SRTP. Looking at several guides looks like a few different methods. ...
Hi TeamSince CCP was retired if I am to implement Telephony on the ISR 4000 series is there a replacement or will i have to do all configuration via CLI? thanks
Hi,Once I open the RTMT I am getting this error message as shown in the attached file.I checked the AMC service on the 10.182.9.227 (Publisher IP) and its up. The other node (10.182.9.228) appears to be functionning normally. Please advice ...
Have a user that we're replacing her old 8821 with a new 8821. She has 118 contacts on the old phone. Is there a way to copy them over into the new one through Call manager?
Hi Guys,We installed 03 IP Phone model 7821 in specific site and we verifying that the is only possible hear the dialtone after dial the second digit. We have the same model in anothers site and not have this problem. Any have about idea for this? I ...
Hello,we are stilll using a isr2900 router as a SBC.Currently it uses the securityk9 license and a uck9-cme-srst-cube license as smart licensing.The logging output tells me that the evalution period already expired.I know the product is EOL/EOS but s...
