My cluster is over the wan. So you think the port could be different from the link? I found a CCM tcp/udp port which mentions 11000-11999 for the H323/H245. I may use this range if no other document specifies the exact port or ranges.
Yes, i am doing an ACL to mark the GUP packets to CS3. Assuming this is what Cisco recommended to be same as all the call setup signal markings.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.