Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Grouping BRI Voice Lines

Hi Guys,

I am looking for a way to group a number of BRI lines for outgoing calls. Basically we have 5 BRI lines and I obviously need to be able to spread my outgoing calls accross these lines. The system is a CME 4.0 running on a 2851 ISR.

I have done this before but can't remember the config, any help gratefully recieved.

Thanks

3 REPLIES
Bronze

Re: Grouping BRI Voice Lines

hi,

try it with "trunk group" configuration.

1. create a trunk group global

2. assign this on the interface

3. assign this on the dial-peer

HTH

regards

mehmet

Silver

Re: Grouping BRI Voice Lines

Do you mean that you are trying to avoid to have a outbound dialpeer for each BRI that you want to use? Don?t think that is possible and almost sure it is not supported.

Just add dialpeer for each BRI, give them all the same preference and you?re good to go ;-)

HTH,

Leo

Hall of Fame Super Gold

Re: Grouping BRI Voice Lines

msolak is right. trunk groups are the recommended way to group incoming or incoming lines, giving you the ability of simplifying the configuration using a single dial-peer, and more sophisticated usage selection schemes.

133
Views
5
Helpful
3
Replies