Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

H.323 gateway incomming calls on FXO ports

Hi,

I have an H.323 gateway with CM 4.1. Calls are going out and comming in fine. However, I changed the plar command on the voice port to plar to a diffrent extension. I updated the corresponding dial-peer, but it is not working. Calls can still come in on other ports and go out, but they are just not working on the port I changed the plar for.

Is there something I need to reset for this to work. I verified that the CSS and partition is not the issue. I can call the same DN from a phone in the same partition and CSS. I tried reseting the CTI route point, but that did not work. I verified that the dial-peer is being hit, but I just get a busy signal immediatly once the call hits the gateway.

voice-port 0/1/0

supervisory disconnect dualtone mid-call

echo-cancel coverage 32

timing hookflash-out 500

connection plar 1751

description *** 377-6965 ***

caller-id enable

dial-peer voice 20 voip

preference 1

destination-pattern 1751

session target ipv4:10.150.152.6

dtmf-relay h245-alphanumeric

no vad

1 REPLY
Anonymous
N/A

Re: H.323 gateway incomming calls on FXO ports

The connection plar command needs to be configured on all of the voice-ports.Change the configuration to slow start so that it will work.

138
Views
0
Helpful
1
Replies