Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H.323 & MGCP on the same Gateway - Is it posible?

Hi,

I have 2x 2951 Gateways each containing 2x VWIC2-2MFT-T1/E1 cards.

Both cards on Gateway one will be H.323, so no problems there.

However on Gateway two I need one card to be H.323, and the other card MGCP for connection to an Erricsson MD110.

Can this be done?

Call Manager is 7.1(3b)

Thanks

Craig

1 REPLY
Cisco Employee

Re: H.323 & MGCP on the same Gateway - Is it posible?

Yes, you can have both protocols running. If you want you can also have SIP and SCCP.

As long as you tie the endpoints to each protocol there is no problem.

Just make sure 1 pri group has MGCP as control protocol and left the other one withtout service mgcp.

The config the dial-peers and use the 2nd one as port.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
469
Views
0
Helpful
1
Replies