Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H.323 Trunk selection order - failed trunk

When using MGCP with CUCM if there is a failed trunk, it realizes it's failed and jumps to the next trunk.

When using H.323 (my personal preference) if the trunk it choses does not work, it simply fails dropping fast busy to the end user - making the rest of the lines useless. Is there a command in the IOS to tell it to try the next trunk in a trunk list in the event of failure?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: H.323 Trunk selection order - failed trunk

change this on CUCM

Clusterwide Parameters (Route Plan)

Stop Routing on Unallocated Number Flag = False

Stop Routing on User Busy Flag = Flag

or on GW:

no dial-peer outbound status-check pots

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

Re: H.323 Trunk selection order - failed trunk

change this on CUCM

Clusterwide Parameters (Route Plan)

Stop Routing on Unallocated Number Flag = False

Stop Routing on User Busy Flag = Flag

or on GW:

no dial-peer outbound status-check pots

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
171
Views
0
Helpful
1
Replies