H323 advice

[iptuser55]

It may be a stupid question but my brain is dead at the moment

I have GW 1 registered to a CCM using MGCP which in turn connects to GW2 using a E1 WIC on each GW with RJ45 cable between them. GW2 then provides VOIP dial-peer pointing to other GW`s in our Clound - this second GW is not registered to CCM.

Question - I want to do away with the first MGCP GW and the physical RJ45 conenction and connect directly to the second GW wihtout any physical connection ,almost like Gatekeepe,Trunk connection - can I configure the GW2 as a H323 device on CCM and use VOP dial-peers to point back to CCM ?

Thanks

[paolo bevilacqua · Accepted solution]

Yes, absolutely.

[iptuser55]

Thanks for the quick answer

CUCM DN`s 1...

Do I just add a H323 GW in CCUM and on the GW do I

create Dial-peer voice xxxx voip

Destination-Pattern 1...

Session TargetIPV4:X.X.X.X- CUCM IP address

Outbound to Clound

Dial-peer voice YYYY VOIP

Destinatio-Patterns 2...

session target ipv4:- next GW

Is this ok ?