Guys, i wonder if anybody can help. I'm having a problem with the BRI ports on two gateways. one is showing BRI0:0 multiple frame established BRI0:1 tei assigned. 0: up up 0:1 up down. only thing i'm unsure about is encapsulation type is voice.
2nd gateway shows both channels as up up but both only at TEI assigned and debug q921 shows no output at all. again encap is voice and i'm unsure if it should be hdlc, ppp etc.
2800 routers. 12.4 wic 1bri.
anything you can suggest i check/change or does it point to service providor fault???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.