Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

h323 config for uk and us

Hello,

does anyone have a sample config for a h323 gateway for implementation in the UK, and one for the US?

Thanks...MS.

5 REPLIES
Hall of Fame Super Gold

Re: h323 config for uk and us

Hi,

you have to not look at the country, but the type of application you are doing. for example, are you connected to PBX ( specify which type and interface) to telco (again specify which interface) and more importantly, what are you trying to do.

New Member

Re: h323 config for uk and us

Hello,

this will be a CCM Gateway, with an E1 in UK, and T1 in US.

My concern is that just having a single .T peer will mean timeout delays, especially with variable length dial patterns. Here in AU, I use a template has about 8 dial peers to cover the variable length patterns.

Does that make sense?

I've attached an AU template that I use...

Hall of Fame Super Gold

Re: h323 config for uk and us

Yes it make sense. However, if you use CCM, the correctness of the called number is enforced first at CCM level. I understand that there are CCM templates circulating for both UK and the US. Try posting as 'CCM dialplans for US and UK'.

So, it is safe to use destination-pattern with T on the gateway. If you want to configure it with the correct destination-patterns, you can do that, but it is not necessary.

Hope this helps, please rate post if it does!

New Member

Re: h323 config for uk and us

Hi and thanks for the reply which helps a lot.

one quick thing though - with SRST, which I forgot to mention - I'm guessing that the user might then experience delays in that circumstance...agree?

in the meantime I'll post for UK dial plans...thanks again...MS.

Hall of Fame Super Gold

Re: h323 config for uk and us

You are right, in case of SRST operation, users may get a small post-dial delay when no punctual DPs configured.

But, using interdigit timeout set to a reasonable value of 4, it is not really a big issue.

158
Views
4
Helpful
5
Replies
CreatePlease to create content