Say I have 2 gateways gw1 and gw2. gw1 is setup as an h232 gateway with 8 POTS lines. And gw2 is set up as MGCP with a PRI. I would like to be able to failover outbound calls to gw2 if all the lines POTS lines on gw1 are in use.
Currently I have the Route List set up with both gw1 and gw2 in it so if they where both mgcp gateways I think it would work. However the h323 gateway doesn't seem to send any thing back to call manager to let it know it's full. So when a call is placed when all the POTS lines on gw1 are full the caller just gets dead air.
Does anyone know if there is a way to make this work?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...