08-04-2007 06:40 AM - edited 03-14-2019 10:56 PM
Hi,
CCM5.1.2, IOS12.4.11.T3, VIC2-4FXO
when I dial out via FXO, CCM sending to gateway the calling number '4501119991' successfully but lost in gateway and cannot send out to PSTN.
Advise please,
!
configuration
--------------
voice-port 0/0/0
connection plar opx 5100
caller-id enable
!
...
dial-peer
---------
dial-peer voice 220 pots
destination-pattern 9[2-9]..[2-9]......
port 0/0/0
forward-digits 10
!
debug voice dialpeer
--------------------
*Aug 4 14:39:14.722: //-1/00BB48670C00/DPM/dpAssociateIncomingPeerCore:
Calling Number=4501119991, Called Number=94502223333, Voice-Interface=0x0,
Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE,
Peer Info Type=DIALPEER_INFO_SPEECH
*Aug 4 14:39:14.722: //-1/00BB48670C00/DPM/dpAssociateIncomingPeerCore:
Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=101
*Aug 4 14:39:14.722: //-1/00BB48670C00/DPM/dpAssociateIncomingPeerCore:
Calling Number=4501119991, Called Number=94502223333, Voice-Interface=0x0,
Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE,
Peer Info Type=DIALPEER_INFO_SPEECH
*Aug 4 14:39:14.722: //-1/00BB48670C00/DPM/dpAssociateIncomingPeerCore:
Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=101
*Aug 4 14:39:14.730: //-1/00BB48670C00/DPM/dpMatchPeersCore:
Calling Number=, Called Number=94502223333, Peer Info Type=DIALPEER_INFO_SPEE
CH
*Aug 4 14:39:14.730: //-1/00BB48670C00/DPM/dpMatchPeersCore:
Match Rule=DP_MATCH_DEST; Called Number=94502223333
*Aug 4 14:39:14.734: //-1/00BB48670C00/DPM/dpMatchPeersCore:
Result=Success(0) after DP_MATCH_DEST
*Aug 4 14:39:14.734: //-1/00BB48670C00/DPM/dpMatchPeersMoreArg:
Result=SUCCESS(0)
List of Matched Outgoing Dial-peer(s):
1: Dial-peer Tag=220
Solved! Go to Solution.
08-04-2007 06:59 AM
Yes, you cannot send calling number on analog lines. If you want to do that, get ISDN.
08-04-2007 06:55 AM
it may stupid question since the analog calling number (outbound) is controlling by carrier. cannot send out my calling number. Am I correct?
Thanks,
08-04-2007 06:59 AM
Yes, you cannot send calling number on analog lines. If you want to do that, get ISDN.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: