Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

H323 gateway configuration with E1 PSTN

Hello,

can somebody help me with a configuration template/example for a H323 gateway that is connected to the PSTN via an E1 controller.

Thanks in advance!

1 REPLY

Re: H323 gateway configuration with E1 PSTN

Friend

what are the digits that will be sent to you by the provider

here is a sample config

card type e1 1 1 (required for 2Gen cards)

controller E1 1/0

framing NO-CRC4 (will depend on ur service provider)

pri-group timeslots 1-31

isdn switch-type primary-net5

dial-peer voice 1 pots

destination-pattern 9.T

incoming called-number .

direct-inward-dial

port 1/0:15

!

dial-peer voice 2 voip

destination-pattern 800 (will depend on the digits sent)

session target ipv4:

Also you will have to use a translation pattern to translate the digits that are sent by ISP to your extension range

HTH

Narayan

329
Views
0
Helpful
1
Replies
CreatePlease to create content