Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

H323 Gateway - forcing outbound calls down a particular E1 Port.

Hi,

We have setup a H323 VGW with 2 E1 circuits attached.

Each circuit has it's own DDI Range applied to it.

The problem we face is that when calling out from the phones with the DDI Range

on circuit 2 it is routing out of circuit 1 and showing an incorrect CLI.

 

Is there a way to forces calls from DDI Range 1 to route out via 0/0/0

and DDI Range 2 to route out via 0/0/1

 

Regards

 

Dominic

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

If this is CUCM then the

If this is CUCM then the easiest way is to use steering codes, build separate CSS/PT/Route patterns/Route List/etc for the second group of phones and prefix a digit string at the Route group or route list level, then have different set up dial-peers matching based on those digits that point to the desired PRI.

Hall of Fame Super Silver

Sure,dial -peer one points to

Sure,

dial -peer one points to one trunk group, dial-peer 2 points to another with extra off-net digit:

dial-peer voice 1 pots
 trunkgroup Local-PRI
 description Local Trunks, Local calls
 destination-pattern 81[2-9]..[2-9]......
 progress_ind setup enable 3
 progress_ind progress enable 8
 forward-digits 11

 

dial-peer voice 2 pots
 trunkgroup LD-PRI
 description LD Trunks LD calls
 destination-pattern 881[2-9]..[2-9]......
 progress_ind setup enable 3
 progress_ind progress enable 8
 forward-digits 11

 

 

5 REPLIES
Hall of Fame Super Silver

If this is CUCM then the

If this is CUCM then the easiest way is to use steering codes, build separate CSS/PT/Route patterns/Route List/etc for the second group of phones and prefix a digit string at the Route group or route list level, then have different set up dial-peers matching based on those digits that point to the desired PRI.

Community Member

Thanks Chris for your help -

Thanks Chris for your help - you wouldn't have an example dial-peer/config I could take a look at by any chance?

 

 

Hall of Fame Super Silver

Sure,dial -peer one points to

Sure,

dial -peer one points to one trunk group, dial-peer 2 points to another with extra off-net digit:

dial-peer voice 1 pots
 trunkgroup Local-PRI
 description Local Trunks, Local calls
 destination-pattern 81[2-9]..[2-9]......
 progress_ind setup enable 3
 progress_ind progress enable 8
 forward-digits 11

 

dial-peer voice 2 pots
 trunkgroup LD-PRI
 description LD Trunks LD calls
 destination-pattern 881[2-9]..[2-9]......
 progress_ind setup enable 3
 progress_ind progress enable 8
 forward-digits 11

 

 

Community Member

Thanks Chris - Much

Thanks Chris - Much Appreciated.

Regards

Dominic

Hello Dominice, Could you

Hello Dominice,

 

Could you share your gateway config detail as I'm also implementing the same setup.

Regards,

Raaj.

152
Views
0
Helpful
5
Replies
CreatePlease to create content