I have a location with an h323 gateway connected to a fractional PRI and two FXO ports. This is a new install and I have the PRI working fine, however I'm not sure how to configure the analog overflow. From what I understand if the PRI is down all of the DIDs and main numbers will ring to the two analog lines. I also need to have outbound dialing overflow to the FXO ports.
You do not configure anything for inboud, that is controlled by telco, DIDs will not overflow to POTS lines, they can only forward them to the POTS line numbers in which case you will need to desigante who the call goes to, this would be done via plar configuration on the pots voice port.
For outbound overflow the configuration depends on what protocol you are using to control the GW, if H323/SIP then simply build redundant dial peers with preference setting, if MGCP add these ports to the Route Group.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...