Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 gateway reoder tone

I have CUCM version 6 running in standard configuration with a h.323 gateway connecting to Nortel PABX. When I make a call from an IP phone through the PABX to a PABX phone or a PSTN phone (which connects through the PABX) the call connects fine but when either party hangs up I get a re-order engaged tone .

Any ideas.

4 REPLIES

Re: H323 gateway reoder tone

What interface did you use for your integration with Nortel?

New Member

Re: H323 gateway reoder tone

Hi

We are using a E1 with QSIG signaling . Here is some of the config.

!

voice call disc-pi-off

voice call convert-discpi-to-prog

voice rtp send-recv

!

voice service pots

!

voice service voip

signaling forward unconditional

h323

!

!

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g711alaw

codec preference 3 g729r8

!

!

!

voice class h323 1

h225 timeout tcp establish 3

!

ontroller E1 0/0/0

pri-group timeslots 1-31

description Nortel B15

!

controller E1 0/0/1

pri-group timeslots 1-31

description Nortel B15

interface Serial0/0/0:15

no ip address

encapsulation hdlc

no logging event link-status

isdn switch-type primary-qsig

isdn timer T203 30000

isdn timer T310 60000

isdn overlap-receiving

isdn protocol-emulate network

isdn incoming-voice voice

no isdn T309-enable

no cdp enable

Re: H323 gateway reoder tone

Config looks good, but i am not sure but did you try providing clocking on your E1 interfaces.

New Member

Re: H323 gateway reoder tone

Can you post a call that fails to disconnnect while running the following debug on the gateway?

debug isdn q931

129
Views
0
Helpful
4
Replies