Hex representation of the RELEASE COMPLETE TPKT to send
**** 10 seconds later you send Release Complete. You never sent Alerting, so the T310 timer expired between the proceeding and alerting call states. Most likely cause is a problem with the subsequent POTS leg of the call, or if this is IP2IP gateway, the second IP call leg.
issue was with Route pattern...strange but ppl at one site were able to call through route pattern X with css Y.....ppl at othe site were not using the same RP and css Y....deleted the rp and re-creted the same....everything works fne now
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...