07-27-2007 05:09 AM - edited 03-14-2019 10:48 PM
I am configuring an H323 PRI gateway in CCM, which connects to a third party's PBX. I would like to designate the CCM gateway as the "Network" side of the PRI, and the other vendors PBX as "User".
How can I specify the Network function on the CCM side?
Thanks
Solved! Go to Solution.
07-27-2007 05:22 AM
controller e1 x/y
clock source internal
interface serial x/y:23 (or 15 for e1)
isdn protocol-emulate network
and check correct cabling (crossed T1/e1 per card pinout). Do not use ethernet patch or crossed!
That's it.
Hope this helps, please rate post if it does!
07-27-2007 05:22 AM
controller e1 x/y
clock source internal
interface serial x/y:23 (or 15 for e1)
isdn protocol-emulate network
and check correct cabling (crossed T1/e1 per card pinout). Do not use ethernet patch or crossed!
That's it.
Hope this helps, please rate post if it does!
07-27-2007 06:11 AM
Thanks for the nice rating and good luck!
If any problem with calls, remember to include output of "term mon" and "debug isdn q931".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: