Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

H323 PRI Gateway User/Network config

I am configuring an H323 PRI gateway in CCM, which connects to a third party's PBX. I would like to designate the CCM gateway as the "Network" side of the PRI, and the other vendors PBX as "User".

How can I specify the Network function on the CCM side?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: H323 PRI Gateway User/Network config

controller e1 x/y

clock source internal

interface serial x/y:23 (or 15 for e1)

isdn protocol-emulate network

and check correct cabling (crossed T1/e1 per card pinout). Do not use ethernet patch or crossed!

That's it.

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Gold

Re: H323 PRI Gateway User/Network config

controller e1 x/y

clock source internal

interface serial x/y:23 (or 15 for e1)

isdn protocol-emulate network

and check correct cabling (crossed T1/e1 per card pinout). Do not use ethernet patch or crossed!

That's it.

Hope this helps, please rate post if it does!

Hall of Fame Super Gold

Re: H323 PRI Gateway User/Network config

Thanks for the nice rating and good luck!

If any problem with calls, remember to include output of "term mon" and "debug isdn q931".

128
Views
0
Helpful
2
Replies
CreatePlease to create content