Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 SRST Dial-Peer Configuration

Our gateways are currently configured with H323 (no MGCP) and I am working on the dial peer design for the fail over scenario. Do I need a final dial peer with the lowest preference pointed at the ip address of the interface that is bound to H323? My instict says yes, but I am having difficulty finding documentation to support that thought. I added it in the template and I am being asked why I need the final dial peer. In the past I have always put this dial peer in. Any thoughts?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: H323 SRST Dial-Peer Configuration

No, there is no need for a dial peer pointed to a local IP address. You simply need dial peers pointed to the port(s) used for PSTN connectivity.

Hope this helps. If so, please rate the post.

Brandon

1 REPLY

Re: H323 SRST Dial-Peer Configuration

No, there is no need for a dial peer pointed to a local IP address. You simply need dial peers pointed to the port(s) used for PSTN connectivity.

Hope this helps. If so, please rate the post.

Brandon

238
Views
0
Helpful
1
Replies
CreatePlease login to create content