Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 trunk between uc540 and panasonic ncp500

hi friends,

i am trying to do h323 trunk between uc540 and panasonic ncp500

i am not able to pass the calls between the systems

i am attaching my uc540 config and error log in uc540 while i am trying to call from cisco phone

my uc540 ip 10.0.0.3

ncp500 is 10.0.0.250

i am waiting for good reply

thanks

cyril

4 REPLIES
Cisco Employee

Re: H323 trunk between uc540 and panasonic ncp500

HI there,

Rather than trying to decode the HEX, it'd be much more easier if u can grab following

debugs for one failed call attempt:

deb voip ccapi inout

deb h225 asn1

deb h245 asn1

Pl. specify calling/called#  and call direction.

DK

New Member

Re: H323 trunk between uc540 and panasonic ncp500

hi dilip,

i am attaching the debug output which you asked

and the details

number 309 is cisco

number 103 is ncp500

calling from cisco to panasonic

thanks

cyril

Cisco Employee

Re: H323 trunk between uc540 and panasonic ncp500

Panasonic is sending h225 Release Complete with cause (88 - Incompatible Destination)

in response to the setup from Cisco UC5xx:

00939: Oct  7 17:40:19.381: //47/C93B47A6806B/CCAPI/cc_api_call_disconnected:
   Call Entry(Responsed=TRUE, Cause Value=88, Retry Count=0)

Not sure what's going on the Panasonic end, but try following on the IOS/UC......

cut-n-paste following at global config prompt (conf t)

voice service voip
no supplementary-service h450.2
no supplementary-service h450.3
h323
  h245 tunnel disable
  h245 caps mode restricted

New Member

Re: H323 trunk between uc540 and panasonic ncp500

hi dilip ,

thanks

its is some codec mismatch problem so now between the devices i can call

but i need one more requirement from cisco uc phones i need to take panasonic pri line to call outside mobiles and landline numbers

i created two dial-peers ,the first one is for extension dialing and second one is for to take panasonic pri line and then dial outside.

is it the correct way or else it is worng... and i am dialing like 89050............

in this 8 is to access h323trunk, and normally in panasonic 9 is to dialout and 050.....is outside number.

can u helpme in that

dial-peer voice 5000 voip
description *** CCA BACD ***
destination-pattern 1..
session target ipv4:10.0.0.250
incoming called-number .
dtmf-relay h245-alphanumeric
no vad

dial-peer voice 5001 voip
description *** CCA BACD ***
destination-pattern 8T
session target ipv4:10.0.0.250
incoming called-number .
dtmf-relay h245-alphanumeric
no vad

596
Views
0
Helpful
4
Replies
CreatePlease to create content