Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hardcoding PRI channels for Inbound & Outbound Calls

Hi,

I have a critical requirement. Can someone help me on this:

I Have 3 ISDN PRI links terminating on Cisco 2821 Routers. 2 Links in one 2821 & 1 link in 1 Router. These PRI details are listed below:

PRI (1) 30c - 04 8704000

PRI (2) 30c - 04 8704200

PRI (3) 30c - 04 8704400

Is the following possible?

Business Centre A: 048704400 (Main/reception number) to 443 with 10 channel

Business Center B: 048704444 (Main/reception number) to 599 with 10 channel

Business Center C: 04870200 (Main/reception number) to 299 with 10 channel

Business Center D: 04870300 (Main/reception number) to 399 with 10 channel

Business Center E: 048704000 to 199 (Main/reception number) to 199 with 20 channel.

I have CUCM 7.1.2 & my Gateways are registered as MGCP to CUCM.

Can someone suggest me whether this is possible or not...

Rgds,

Partha

9 REPLIES
Hall of Fame Super Gold

Re: Hardcoding PRI channels for Inbound & Outbound Calls

Certainly not possible with MGCP.

If using H.323 or SIP, you can use max-conn or trunk-groups to limit number of calls per destination.

New Member

Re: Hardcoding PRI channels for Inbound & Outbound Calls

Hi,

Thanks for your reply...

In H.323 can this be achieved for both inbound & outbound calls? Kindly suggest..

Rgds,

Partha

Hall of Fame Super Gold

Re: Hardcoding PRI channels for Inbound & Outbound Calls

As mentioned before, separated DPs per number, and max-conn.

Please remember to rate useful posts clicking on the stars below.

Re: Hardcoding PRI channels for Inbound & Outbound Calls

you can control outbound calls using the metheds mentioned by Paolo ( what cahnnel/line to use ) but inbound call controled by the Telco

you may contact them and see if they can help you to get the inbound calls setup as you want

good luck

if helpful Rate

Hall of Fame Super Gold

Re: Hardcoding PRI channels for Inbound & Outbound Calls

OP only needs to limit number of calls toward certain numbers, not to control the specific channel used.

Consequently, max-conn under voip DP will suffice for calls inbound to CM.

New Member

Re: Hardcoding PRI channels for Inbound & Outbound Calls

Can I control inbound as well as Outbound calls as per your

suggestion....other members on the same topic has told that Outbound

calls can be controlled but not inbound calls. Can u kindly suggest or

can share some doc with me...

Rgds,

partha

Hall of Fame Super Gold

Re: Hardcoding PRI channels for Inbound & Outbound Calls

This limits call from telco to CM.

From what I understand, other way around is not of interest for you.

New Member

Re: Hardcoding PRI channels for Inbound & Outbound Calls

Hi,

Thanks a lot for your generous reply...

So my requirement will be meet as per your suggestion. Based upon your

suggestion I am committing to the end customer....Kindly share some doc

if possible..

Hall of Fame Super Gold

Re: Hardcoding PRI channels for Inbound & Outbound Calls

There are no special docs for this, standard documentation applies.

492
Views
5
Helpful
9
Replies