I am trying to configure a Voice gateway AS5400 to route call from ISDN E1 to to a SIP server, I have configured the dial-peers , but when I try to make a call form , I hear noise like a modem voice I have been reading on Cisco website on this problem and they said all you need is to add the command "incoming called-number ." but still I am hearing the same noise
ISDN E1----------------AS5400 Voice Gateway -----------------------SIP Server
here is my configuration for the dial-peers
dial-peer voice 2 voip destination-pattern 00.T session protocol sipv2 session target sip-server session transport udp dtmf-relay rtp-nte
incoming called-number 00 .T codec g729br8 ! dial-peer voice 1 pots incoming called-number 00 .T direct-inward-dial port 7/3:D forward-digits all
if you guys can take a look at it and see if I did something wrong.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...