having a slight issue an was wondering if anyone could assist.
i have an FXO/FXS setup on two routers. the FXO router has PSTN lines terminated and we are using the WAN to go to the other router that has the FXS and two analog phones. Now everything works fine withthe exception that if a call comes into the PSTN and goes directly to the Analog phone at the other end (Using PALR connection) when the analog user picks up the phone, they hear the dialed digits. the conversation is fine after that but it seems to have a signaling issue.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...