Help for configuring Cisco Unity Express on ISM-SRE-300-K9 module (on a Cisco 2921 CME router)
We have purchased a Cisco 2921 router for Call manager express. For installing Cisco Unity express, we have installed an ISM-SRE-300-K9 module on the Cisco 2921 (motherboard). I have read Cisco documentation and some blogs regarding configuration of the ISM-SRE-300-K9 and accessing it, but I am still not sure about the procedure.
Also, I see the interfaces Embedded-Service-module 0/0, ISM0/0 and ISM0/1 on the router. Could you please let me know which of these (or all?) will be used for Cisco unity express? Could you please let me know what each of these interfaces is used for?
Could you please point me to the exact procedure for configuring and accessing ISM-SRE-300-K9 for CUE functionality?
I have a brand new 2911 and I have tried every different way for installing CUE on this particular module and nothing has worked. I even RMA'd it and the new one is acting the same way. After I installed the new ISM and powered on the device the status showed it was trying to recover from an error. Has anyone else had as bad of a time as me with this thing?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.