I checked the logs. you called 0908043018 and I can see outgoing dial peer 2 was matched but for some reason immediately call was disconnected. Could you check whether fxo port is correctly applied in dial peer 2 also share "show run"
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.