Hello everyone, I'm a VoIP newbie and I've built my lab for voice. I've successful Installed CUCM 7 and intergraded my LDAP. I've already configured my calling spaces, and my ext and learned how to associate it with a LDAP account. I'm running into a couple of issues. I'm trying to figure out how to setup Caller ID to work in the CUCM when calls are coming in from the PSTN. I've played around with CCME and I've gotten the phones to work when I created my dial-peers (IOS CLI). I as able to make the dial-pattern and the correct format for local calling (i.e 9770 and ie91800, and long distance. Now my question is this how do I get that working again with CUCM 7?
I plan on using H.323 so I can get Caller ID working on my FXO interface on my router, and my goal is to connect my router to the local Telco and make calls. It seems very challenging. Once I've achived this I'll be moving on to study and take my CVOICE test. Any ideas or advice?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...