Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help with setting up Caller-id on FXO in 2911 H.323 gateway.

I have a remote site that has a couple of POTS lines terminating to a FXO on the 2911.  This remote site is an H.323 gateway in a CUCM 8.6 cluster.  Incoming local calls for that location ring all phones at the location.

What do I need to do to enable Caller-id on these POTS lines terminating to the FXO?  I am pretty sure the carrier is sending the caller ID information. 

Thanks       

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions

Help with setting up Caller-id on FXO in 2911 H.323 gateway.

Hi

1- Please find the below table  as the following link  http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml

Caller IDRequires VIC-2FXO-M1, VIC-2FXO-M2, VIC-4FXO-M1, VIC2-2FXO, VIC2-4FXO, or MRP3-8FXOM1

2- under fxo port

voice-port 0/3/0

caller-id enable

3-If the above configure and still have no caller id , please add the below commannds to the voice-port

caller-id alerting line-reversal

cptone ?               "based on your"

caller-id alerting ring 2    "the default is 1" maximum number of rings to be detected before a call is answered over an FXO voice port.


4-Do debus to make sure all ok

"debug vpm signal "

[0/3/0] get_fxo_caller_id:Caller ID received. Message type=128 length=31 checksum=74

Thank you

please rate all useful information


1 REPLY

Help with setting up Caller-id on FXO in 2911 H.323 gateway.

Hi

1- Please find the below table  as the following link  http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b53c7.shtml

Caller IDRequires VIC-2FXO-M1, VIC-2FXO-M2, VIC-4FXO-M1, VIC2-2FXO, VIC2-4FXO, or MRP3-8FXOM1

2- under fxo port

voice-port 0/3/0

caller-id enable

3-If the above configure and still have no caller id , please add the below commannds to the voice-port

caller-id alerting line-reversal

cptone ?               "based on your"

caller-id alerting ring 2    "the default is 1" maximum number of rings to be detected before a call is answered over an FXO voice port.


4-Do debus to make sure all ok

"debug vpm signal "

[0/3/0] get_fxo_caller_id:Caller ID received. Message type=128 length=31 checksum=74

Thank you

please rate all useful information


690
Views
0
Helpful
1
Replies
This widget could not be displayed.