Hello folks, can you please give me a sample article showing how to accomplish the requirement outlined in the attached diagram?
I haven't seen a good article on this specific issue so if you the experts on this could help me showing a configuration for this, I really appreciate it.
1) When calls are placed outbound from Remote Site1 and RemoteSite2 or Hub, "Phone PSAP" should see the STN (Screen Telephone Number) from the respective site calls are coming, so 911 can respond accordingly and identify the respective remote location calls are coming from.
1) In CUCM, which configurations are necessary to make this work (For example, (CSS) Calling Search Space changes, Route Lists, Route Pattern, Route Groug changes in the "CUCM Administrator" service etc)
2) In the CUBE C3925, please provide the configuration which can allow me to accomplish the requirement.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...