CM Admin System version: 220.127.116.1100-5 on C200M2 Servers
Our engineer setup our Call Handlers so that in our to change the recordings on them, you diall 7800 from a phone inside the office, or as he put it in the procedures, from within the district. Once you dial, you need to enter the user code, password, then the extension of the Call Handler, and we have no problems recording/changing any Call Handlers. However, due to possible inclement weather approaching in the next few weeks, I was asked how we cna change them from an outside line (manager's home, etc.). We cannot access from an outside line. 7800 is not a DID, it is simply the extension he assigned to access the call handlers. I even went so far as to setup a dummy phone and forward it to 7800, but this does not work either. It forwards to the extension's voicemail. Is there a way we can access the Call Handlers from an outside line? Any help would be gretaly appreciated. Thank you in advance.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.