Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How can i block the IE Facility Display Name on a mgcp gateway

Hello ,

Caller ID name is sent by our telco ( IE Facility ) and we want to block this on the IP Phone. The Gateway is controlled by mgcp. 

All the checkboxes under "PRI Protocol Type Spezific Information " are unchecked .

Se0/0/1:15 Q931: RX <- SETUP pd = 8  callref = 0x7100

        Bearer Capability i = 0x9090A3

                Standard = CCITT

                Transfer Capability = 3.1kHz Audio

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0xA18382

                Preferred, Channel 2

        Display i = '123456  123456'           #   we want block this number

        Date/Time i = 0x0C061D0C2824

                Date (dd-mm-yr)   = 12-06-29

                Time (hr:mnt:sec) = 12:40:36

Thanks

1 REPLY
Cisco Employee

How can i block the IE Facility Display Name on a mgcp gateway

Under MGCP endpoint config you can choose to change or block calling/called name/number. Just adjust as you want those parameters.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
430
Views
0
Helpful
1
Replies
CreatePlease to create content