Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can i connect CISCO Call manager 8 with Siemens HiPath 3800 v.9

Dear All,

Im  trying to connect Siemens HiPath 3800 V.9 with CISCO call manager 8,  When we make a call from Siemens to CISCO or vise versa the both sites  recive ring but when call is answer there is no voice for 12 second and  call after dropped, Anybody faced this before or have suggestions.

Regards

Zaker

7 REPLIES
VIP Super Bronze

How can i connect CISCO Call manager 8 with Siemens HiPath 3800

Hi,

You probably get better responses if you move you post to the IP Telephony or VOIP section.

HTH

New Member

How can i connect CISCO Call manager 8 with Siemens HiPath 3800

Hi Reza,

Thank you for reply, i have posted now at IP telephony discussions.

Thanks

Zaker

New Member

How can i connect CISCO Call manager 8 with Siemens HiPath 3800

Note: im using H323

Silver

How can i connect CISCO Call manager 8 with Siemens HiPath 3800

Can you send the H225 and H345 messaging?  CallManager Detailed traces should be fine.  Sounds like the H245 (media setup) is failing.  Default Media Exchange timeout is 12 seconds so the call would drop after 12 seconds if that failed.  Do you have Wait for Far End Terminal Capability Set checked under the H323 gateway in CUCM?  You may want to try disabling that and resetting the gateway.

New Member

How can i connect CISCO Call manager 8 with Siemens HiPath 3800

Thanks Brian, I will try it and back to you.

New Member

Re: How can i connect CISCO Call manager 8 with Siemens HiPath 3

Hi Brian,

Hope you are fine.

We have did what you advice up and the situation is changed now.

What is happing now as following: When we call from Cisco to Siemens its ok there is ringing and voice is heard between both parties. But when we call from Siemens to Cisco there is a ring at Cisco phone but when answering the call there is no voice and the line keep open without drop but silent for both sides. please any advice?

Note: By using SIP everything work correct for both sides.

Regards

New Member

Hi Zaker, I am trying to

Hi Zaker,

 

I am trying to integrate Siemens Hi Path 3800 with CUCM 8.x via SIP Trunk. But i am not even able to get the ring back. It is staying idle and getting dropped. Kindly suggest. Please share any document related to configuration part either via SIP or H.323.

 

Regards

Sankar.

885
Views
0
Helpful
7
Replies
CreatePlease login to create content