Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how can i reach my voice mail form outside of the office

hi,

I got 2851 ccme and cue.

config is below

in the office i can dial 7000 and i can reach my voicemails but how can i reach from out of the office..

my DID range 3555700-5799

and ephone-dn s are 57xx-5799

dial-peer voice 2001 voip

destination-pattern 5700 >>AA number

session protocol sipv2

session target ipv4:172.30.10.133

dtmf-relay sip-notify

codec g711ulaw

no vad

dial-peer voice 200 voip

destination-pattern 7000>>Voice Mail number

session protocol sipv2

session target ipv4:172.30.10.133

dtmf-relay sip-notify

codec g711ulaw

no vad

dial-peer voice 1 pots

description calls over pri

translation-profile incoming prefix

destination-pattern 9T

direct-inward-dial

port 0/0/0:15

thanks a lot

3 REPLIES
New Member

Re: how can i reach my voice mail form outside of the office

Hi,

Looks like your voicemail number is out of your DID range.

You got 2 choices, either change 7000 to an extension within your DID range. Or, you can assign a DID number for it, say 5701 and add a translation rule to translate 5701 to 7000.

:)

Eugene

Highlighted
New Member

Re: how can i reach my voice mail form outside of the office

hi,thanks for your answer

you mean config should be like that?

am i right i should apply the rule in the sip dial-peer an as outogoing?

thanks again.

voice translation-rule 10

rule 1 /5701/ /7000/

!

voice translation-profile to_voicemail

translate called 10

!

dial-peer voice 200 voip

TRANSLATION-PROFILE OUTGOING to_voicemail

destination-pattern 7000

session protocol sipv2

session target ipv4:172.30.10.133

dtmf-relay sip-notify

codec g711ulaw

no vad

New Member

Re: how can i reach my voice mail form outside of the office

Hi,

Sorry I'm still pretty green in translations, but it looks good to me.

How about this, add another dial-peer like:

dial-peer voice 200 voip

destination-pattern 7000

session protocol sipv2

session target ipv4:172.30.10.133

dtmf-relay sip-notify

codec g711ulaw

no vad

dial-peer voice 201 voip

destination-pattern 5701

session protocol sipv2

session target ipv4:172.30.10.133

dtmf-relay sip-notify

codec g711ulaw

no vad

:)

Eugene

225
Views
5
Helpful
3
Replies
CreatePlease login to create content