Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How configure 3560 for alcatel OXO and IP Phone 4038

I have to connect a PBX with IP phones Alcatel OXO switch cisco 4038 to 3560.

How do I configure the ports which connect the PBX and the ones where I connected the phone?

Voice vlan 309 - Data VLAN 305.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

How configure 3560 for alcatel OXO and IP Phone 4038

Hi Matteo.

Alcatel IP Phones, should support LDP which means that you can configure phone port as a trunk port with Data VLAN as Native Vlan an Voice VLAN as tagged.

In your case.

Phone ports:

switchport trunk encapsulation dot1q

switchport mode trunk

swtichport trunk native vlan 305

switchport trunk allowed vlan 309

PBX Port:

swtichport mode access

switchport access vlan 309

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"
2 REPLIES

How configure 3560 for alcatel OXO and IP Phone 4038

Hi Matteo.

Alcatel IP Phones, should support LDP which means that you can configure phone port as a trunk port with Data VLAN as Native Vlan an Voice VLAN as tagged.

In your case.

Phone ports:

switchport trunk encapsulation dot1q

switchport mode trunk

swtichport trunk native vlan 305

switchport trunk allowed vlan 309

PBX Port:

swtichport mode access

switchport access vlan 309

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"
New Member

How configure 3560 for alcatel OXO and IP Phone 4038

Thanks for the answer.


Alcatel allows you to configure the PBX with 2 different IP addresses on VLAN 2.
In this case, how should I configure the switch port where I plug in my PBX?

These specifications alcatel:

Alcatel-Lucent OmniPCX Office Communication Server is connected to a switch with the
following characteristics:
-VLAN-aware: a switch that can recognize and support VLAN-tagged frames.
- Each port to which the PowerCPU Board and IP phone sets are connected must be of
hybrid type with the same VLAN identifier (VID). An hybrid port is a switch port configured
to send and receive 802.3 (data VLAN protocol) or 802.1Q (voice VLAN protocol) frames

1476
Views
0
Helpful
2
Replies