Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How configure siemens hipath SIP trunk

hi all

i wish know how configure SIP trunk with Siemens hipath 4000, some example configuration or way.

THX

6 REPLIES
New Member

Re: How configure siemens hipath SIP trunk

Configure the SIP trunk on the Siemens itself or on a Cisco device, such as CME or CM?

New Member

Re: How configure siemens hipath SIP trunk

hi, i need to know how configure in Cisco Call Manager 5.1 with Siemens Hipath 4000 via SIP trunk, without using E1 QSing.

Re: How configure siemens hipath SIP trunk

I would not recommend doing a direct SIP trunk from CM to the Hipath. You will be really limited to what you can do with it. Your best bet is to use a CUBE to interface between the two systems. However, QSIG is the recommend integration type of a Siemens PBX. Here is one document that may help.

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns833/698642.pdf

Here is another link that may be useful.

https://www.myciscocommunity.com/message/8955;jsessionid=574712FBC179928F2D521F7FB506F30F.node0

New Member

Re: How configure siemens hipath SIP trunk

Hi, thanks for the reply, but using E1 controller i will limited for 30 calls only, maybe 15 in / 15 out, and that's not good for me. i have more than 500 Ip phones in both sides, (Siemens and CCM).

i hope you can help me.

Thx.

New Member

Re: How configure siemens hipath SIP trunk

Hello,

Have you checked Siemens docs?

Regards.

New Member

Re: How configure siemens hipath SIP trunk

Hi

Look on Interoperabilty Portal. There are many examples between cisco devices and others supply.

http://www.cisco.com/en/US/netsol/ns728/networking_solutions_program_category_home.html

Att

Peterson

2292
Views
0
Helpful
6
Replies
CreatePlease to create content