How do I configure callmanager or GW H323 to offer busy tone to carrier?
When our faxes receive a second call while busy, the second call overflows to our POTS lines. According to the carrier that happens becuase we are sending a cause code 17 to them which triggers the overflow feature over our ISDN Pri lines. Per the carrier to avoid triggering the overflow we need to send a cause code 31, or some release alert to not trigger the overflow.
In accordance with Cisco TAC the cause code cannot be changed on an H323 GW.
Is there a way to configure callmanager or the GW H323 with a work around that will either send a busy signal to the carrier, or have the system provide a busy signal on the second line?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...