How do I make 8000 and 9000 series phones use <user>@<domain> inside SIP messages
I am using 8000 and 9000 series IP phones and registering them to a non-Cisco SIP proxy. I have done a lot of tweaking with the configuration files but I can't get them to use the <user>@<domain> format inside the SIP messages. The phone is resolving the hostname I use for the "processNodeName" tag and using the IP for that inside the messages instead of the hostname. Does anyone know if there is a way around this?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...