Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How I can know if a phone is connected into VG port?

Hello everyone, I wondering if someone knows a command on VG to know if some device is connected to the voice port.

When I put this command:

VG202#sh stcapp dev sum

Total Devices:           2

Total Calls in Progress: 1

Total Call Legs in Use:  1

Port       Device          Device   Call          Dev     Directory   Dev

Identifier Name            State    State         Type    Number      Cntl

---------- --------------- -------- ------------- ------- ----------- ----

0/0        AN1FCAF21730000 IS       IDLE           ALG     5847       CCM

0/1        AN1FCAF21730001 IS       RINGIN         ALG     5833       CCM

This doesn't guaranteed that analog phone is ringing, because maybe the phone cord is unplugged.

thanks in advance

Alex

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

How I can know if a phone is connected into VG port?

There is no way of knowing that.

3 REPLIES
Hall of Fame Super Gold

How I can know if a phone is connected into VG port?

There is no way of knowing that.

How I can know if a phone is connected into VG port?

Thanks Paolo,

I even tried to compare 2 ports (one with phone hooked up) searching some difference in the output of command "show voice-port" but nothing.

Thanks again for your confirmation.

Alex

Hall of Fame Super Gold

How I can know if a phone is connected into VG port?

You're welcome, please remember to rate useful posts clicking on the stars below.

600
Views
0
Helpful
3
Replies
CreatePlease to create content