Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How I can test H323 telephony for 2 sites without using CUCM?

How I can test H323 telephony for 2 sites without using CUCM?

6 REPLIES
New Member

Re: How I can test H323 telephony for 2 sites without using CUCM

I have 2 gateways with FXS ports:

10.1.1.1 and 10.2.1.1

--10.1.1.1----10.1.1.2--

Can somebody provide me config to connect FXS port for each side and make sides been posible to call from GW1 to GW2 and viceverse

New Member

Re: How I can test H323 telephony for 2 sites without using CUCM

Any answer?

Re: How I can test H323 telephony for 2 sites without using CUCM

Router1:

dial-peer voice x pots

port 0/0/0

destination-patter 1000

dial-peer voice x voip

destination-pattern 1001

session target ipv4:10.0.0.1

Router2:

dial-peer voice x pots

port 0/0/0

destination-patter 1001

dial-peer voice x voip

destination-pattern 1000

session target ipv4:10.0.0.2

-nick

Re: How I can test H323 telephony for 2 sites without using CUCM

Hi,

Use Dial Peers:

http://www.cisco.com/en/US/docs/ios/12_2/voice/configuration/guide/vvfpeers.html#wp1261894

Hope it helps, if it does please rate.

Best regards,

- Adrián.

New Member

Re: How I can test H323 telephony for 2 sites without using CUCM

--10.1.1.1----10.1.1.2--

Can you see now this one topology.

As you see we have Cisco 7206 and PIX firewall in the center of it.

Should I do something in the center of this topology? I mean about configuration of Cisco 7206 and PIX or I should config only routers 10.1.1.1 and 10.1.1.2 ?

Thank you in advance

Re: How I can test H323 telephony for 2 sites without using CUCM

In theory you shouldn't need to configure anything on your firewalls. However, historically speaking, firewalls and voice have had problems working together.

-nick

141
Views
9
Helpful
6
Replies
CreatePlease to create content