Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How Route List work?

Hey,

I would like to add 2 MGCP gateway in a Router list.

But, How CUCM knows if specif gateway is up? By Network conectivity, E1 port status or both?

thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

How Route List work?

You're correct, both are used.

MGCP uses a keepalive method to make sure it's reachable, and also the ISDN status to make sure the endpoint is registered.

If you want more info on how the RG/RL/RP works, it's all explained in the dial plan chapter from the SRND.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
3 REPLIES

Re: How Route List work?

Hello

You have to create two route groups , for 2 X MGCP ports and assign both for RL , but you to make sure from the below:-

1-MGCP ports on CUCM shows registered.

2-On gateway , show ccm-manger "shows you that your GW registered to yur CUCM ".

RL will select the 1st RG on the RL , if the call not reachable by 1st the call will be routed to the 2nd RG.Please find the below

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/dialplan.html#wp1044247

Thank you

please rate all useful information

VIP Purple

Re: How Route List work?

Hi Jean,

I just captured the snapshot from cisco document.

Route List allows Cisco CallManager to hunt through a list of Route Groups in a configured order of preference. A Route List consists of an ordered list of Route Groups. Route Lists expand the Route Groups concept and allow the user to order and prioritize your route groups. Multiple Route Lists can point to the same Route Groups. A Route List chooses a path for call routing and points to prioritized Route Groups.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800949f0.shtml

regds,

aman

Cisco Employee

How Route List work?

You're correct, both are used.

MGCP uses a keepalive method to make sure it's reachable, and also the ISDN status to make sure the endpoint is registered.

If you want more info on how the RG/RL/RP works, it's all explained in the dial plan chapter from the SRND.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
189
Views
0
Helpful
3
Replies
CreatePlease to create content