Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to activate ephone-dn changes in SRST/CME

Hi All,

I’m using SRST fallback mode using Cisco Unified Communications Manager Express (Cisco Unified CME) and its working ok.

Under telephony-service I configured a ephone-dn-template so some settings are pushed to the phones in SRST.

I’d like to disable the call-waiting-beep on the phones, so I changed ephone-dn-template 1 and added the option ‘no call-waiting beep accept’. See configuration below

telephony-service
srst mode auto-provision none
srst ephone template 1
srst dn template 1
srst dn line-mode dual

ephone-dn-template  1
no call-waiting beep accept

I switched between the normal mode and SRST mode, but the ‘call-waiting beep’ is still activated. Eventually the call-waiting beep was disabled after rebooting the router.

Questions:
- Is there a more elegant way the activate these changes on the phones?
- Is there a way to remove a dynamically discovered ephone in SRST/CME?

2 REPLIES
Super Bronze

Re: How to activate ephone-dn changes in SRST/CME

Hi

You could try issuing the reset command under telephony-service config mode to reset the phones...

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: How to activate ephone-dn changes in SRST/CME

Hi Aaron,

I already tried this…. No luck..

Theo

295
Views
0
Helpful
2
Replies
CreatePlease to create content