How to add new trunk lines to actual CM.

[rogeliocabral]

Actually i have configured 20 trunk lines on my Call manager, but now i need to add 10 new trunk lines to have 30 trunk lines, my carrier was confirmed that the new 10 lines is ready for use, but i need to configure the call manager to use these new lines. Somebody know what i need to do?

I have a CISCO model C3725 call manager.

[paolo bevilacqua]

Do you have "call manager" that is a server with software loaded on it, and a separated 3725 router, or do you have "call manager express" that works the router only ?

In any case, begin with doing telnet to the router, and "show run". Copy and past the ouput here. If there are public IP addresses, you can mask them.

[rogeliocabral]

Is a CME:

Please see attached file.

[paolo bevilacqua]

Try this:

voice-port 0/0:0

shutdown

controller e1 0/0

shutdown

no ds0-group 0 timeslots 1-15,17-21 type r2-digital r2-compelled ani

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

no shutdown

voice-port 0/0:0

no shutdown

Note this assume you have enough DSP resources on the NM-HD-xx module, do "show diag" to know.

Hope this helps, please rate post if it does!

[rogeliocabral]

Excellent!

Only one question. This change require that CME must be rebooted?

[paolo bevilacqua · Accepted solution]

No it does not, but it require that there are no active calls. Thank you for the nice rating and mucha suerte!