Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

how to bind both nic of cucm 8 into one NIC phase

Please help me anyone to bind cucm 8.0.2 server both nic cards in one.

so that use in HA mode both NICs.

Warm Regard's =========== Amit
1 REPLY
Hall of Fame Super Red

Re: how to bind both nic of cucm 8 into one NIC phase

Hi Amit,

"NIC Teaming for Network Fault Tolerance

The NIC teaming feature allows a  server to be connected to the Ethernet via two NICs and, therefore, two  cables. NIC teaming prevents network downtime by transferring the  workload from the failed port to the working port. NIC teaming cannot be  used for load balancing or increasing the interface speed.

Hewlett-Packard  server platforms with dual Ethernet network interface cards can support  NIC teaming for Network Fault Tolerance with Cisco Unified CM 5.0(1) or  later releases.

IBM server platforms with dual Ethernet network interface  cards can support NIC teaming for Network Fault Tolerance with Cisco  Unified CM 6.1(2) and later releases. "

And the command to do that as per  the CUCM OS CLI Reference Guide is:

set network failover

This  command enables and disables Network Fault Tolerance on the Media  Convergence Server network interface card.

Command Syntax

failover  {enable | disable}

Parameters

enable enables Network Fault Tolerance.

disable  disables Network Fault Tolerance.

Requirements

Command privilege level: 1

Allowed  during upgrade: No "

The referenced guides:

SRND

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/callpros.html#wp1151635

CLI Ref

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/cli_ref/7_1_2/cli_ref_712.html#wp40017

Cheers!
Rob

278
Views
5
Helpful
1
Replies
CreatePlease to create content