Thank you for your response! I very appreciate it!
The full problem is:
I try to integrate third-party SIP Device (Mobotix T24), CUCM and cisco ip phone 8945. I've registered Mobotix T24 on CUCM as third-party SIP device (advanced) and also I've registered cisco ip phone 8945 as SIP device.
When I call from any endpoint (Mobotix T24 or cisco phone 8945) I can establish just audio call between t24 and phone 8945. When I check call status on cisco phone I see it's receiving video streem with resolution 352x288 but the video never ever displays on cisco phone 8945.
I checked logs from CUCM and I see that third party-device advertise video with rtp payload type - 103 98
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.