How to configure a CTI route point to manage prompts in UCCX
I currently have CTI route points in my environment that when you dial the extension that they are associated with, they direct to lines on CTI Ports dynamically. I need to configure a site that has an auto attendant set up already, but I'm not sure how to get it to point to the script for that site. I'm also not sure how to get the cti route point, when dialed, to redirect to the prompts for that particular site. When you dial the number, it directs you to the cti port and prompts you to enter a pin. How do I set this up or where can I find out documentation on setting this up step by step?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...