Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to configure dial-peer redundancy

Hello all,

i am configuring a voip dial-peer and i have two servers which will be the session target but while i am putting the configuration its not allowing me to give two IPV4 Targets , so how i can give both of them in the config?

dial-peer voice 139 voip

description ****test dial-peer****

service session

destination-pattern 8390

voice-class codec 1

session protocol sipv2

session target ipv4:10.10.11.235

session target ipv4:10.10.11.233 ***Suppose to be secondary

incoming called-number 8390

dtmf-relay h245-signal h245-alphanumeric rtp-nte

no vad

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: How to configure dial-peer redundancy

create two dial-peers with the same destination pattern and add the prefernce command to the dial-peer, the lower the preference the higher the priority

ex:

dial-peer voice 1 voip

destination-target 1...

preference 1

session-tartget ipv4: 192.168.1.1

dial-peer voice 2 voip

destination-target 1...

preference 2

session-target ipv4: 192..168.1.2

here, dial-peer 1 will be used first and then dial-peer 2 as a failover/redundancy

5 REPLIES
Community Member

Re: How to configure dial-peer redundancy

create two dial-peers with the same destination pattern and add the prefernce command to the dial-peer, the lower the preference the higher the priority

ex:

dial-peer voice 1 voip

destination-target 1...

preference 1

session-tartget ipv4: 192.168.1.1

dial-peer voice 2 voip

destination-target 1...

preference 2

session-target ipv4: 192..168.1.2

here, dial-peer 1 will be used first and then dial-peer 2 as a failover/redundancy

Community Member

Re: How to configure dial-peer redundancy

I chaked

the same and its working

thanks.

Community Member

Re: How to configure dial-peer redundancy

mind rating my reply, thanks

Community Member

Re: How to configure dial-peer redundancy

how is it now

Community Member

Re: How to configure dial-peer redundancy

great thanx.

1045
Views
5
Helpful
5
Replies
CreatePlease to create content